- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The CO2 Sensor board can not connect to the PC software.
Solved! Go to Solution.
- Labels:
-
CO2 Sensor
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
There are two versions of XENSIV PAS CO2 Sensor2Go GUI till now (2021 Sep 29th)
For version 1.1.2 you need to check in the box where the sensor shows and then press connect. (see picture version 1-1-2 below)
For version 2.8.0 the sensor is connected automatically after you connect the USB port. (see picture version 2-8-0 below)
So you may want to update your Toolbox and CO2 Sensor2Go GUI to newer version.
Note: You can choose which version to start from the toolbox start up screen (see picture version-change below)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
There are two versions of XENSIV PAS CO2 Sensor2Go GUI till now (2021 Sep 29th)
For version 1.1.2 you need to check in the box where the sensor shows and then press connect. (see picture version 1-1-2 below)
For version 2.8.0 the sensor is connected automatically after you connect the USB port. (see picture version 2-8-0 below)
So you may want to update your Toolbox and CO2 Sensor2Go GUI to newer version.
Note: You can choose which version to start from the toolbox start up screen (see picture version-change below)