Mar 26, 2021
06:34 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 26, 2021
06:34 AM
How can I recreating a finger touch for an automatic darution test of the CapSense Button of the Endproduct. (e.g. a metal plate or an resistor switch to GND?
Solved! Go to Solution.
Labels
- Labels:
-
Sensing Technologies
1 Solution
Mar 28, 2021
10:40 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 28, 2021
10:40 PM
Hi @bgo
It is recommended to use a metal finger connected to ground for testing CapSense as this closely resembles a human finger. You can use one of 8 mm diameter since that is considered as a standard human finger size.
Best regards,
Hari
1 Reply
Mar 28, 2021
10:40 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 28, 2021
10:40 PM
Hi @bgo
It is recommended to use a metal finger connected to ground for testing CapSense as this closely resembles a human finger. You can use one of 8 mm diameter since that is considered as a standard human finger size.
Best regards,
Hari