- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I tried to add proximity to a few of the CapSense examples in Modus Toolbox but have not had success getting it working.
I had easily added it in a similar manner to my 062-BLE board.
Is there an example or instructions that can be shared to make use of the proximity loop in the dev kit?
Thanks,
Greg
Solved! Go to Solution.
- Labels:
-
CapSense
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Greg,
Please find the proximity sensor project attached. You may explore the capsense configurator
I have used shield in the project to demonstrate shield usage, which is optional. You may proceed without any hardware changes. Make sure you disable shield option in the project too if not used.
Regards,
Nikhil
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Greg,
Please find the proximity sensor project attached. You may explore the capsense configurator
I have used shield in the project to demonstrate shield usage, which is optional. You may proceed without any hardware changes. Make sure you disable shield option in the project too if not used.
Regards,
Nikhil
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks Nikhil!
The project is just what I needed 😃
-Greg