- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I have just written wiced_sleep_config(WICED_TRUE, NULL, NULL) in code and I am getting 2 different reading of both board
This the board given by local Cypress vendor
All LEDs are disconnected. This board gives current 0.1 mA and now when I tried on my board
It shows 12.3 mA current. Nothing else is connected. Also I have confirmed that code is successfully programmed by using PUART.
Why so? I am checking current across VDDIN line. Nothing is else is connected in both board. Is there anything that I am missing to connect or something else?
Where I am wrong?
Thanks and regards
@NeerajDhekale
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello
there was a problem with the controller. I tried replacing the controller and it works.
Thanks and regards
Neeraj
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
May I know in which power mode the devices are running?
Also the device configuration (eg. Peripheral access) and other conditions while measuring the current?
Please make sure the initial conditions are same before measuring the current.
You can measure the current across VDDIN. In case the EVAL board you can use the Jumper J2.
Thanks,
-Dheeraj
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello
there was a problem with the controller. I tried replacing the controller and it works.
Thanks and regards
Neeraj
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content