- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I have some question about the filter mode of TIM.
1. The up/down counter mode with rising edge, after F_OUT reaches High level, does the FLT_CNT decremented?
2. The Hold counter mode with rising edge, after F_OUT reaches High level, how does the FLT_CNT reset? If the cnt can't be reset, does it means the filter only can work one time?
Best Regards
Jamber
Solved! Go to Solution.
- Labels:
-
AURIX
- Tags:
- tim
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @Jamber
1) Does the FLT_CNT decremented?
-- No, I'm afraid not, unless a falling edge occurs.
2) If the cnt can't be reset, does it means the filter only can work one time?
-- For the FLT, it only can detect the rising edge but also the falling edge, it can reset the FLT_CNT when a low level reaches the filer parameters. In other words, it seems like an opposite mechanism versus detecting the rising edge.
BR,
Jeremy
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The filter counter register FLT_CNT is incremented when the signal level on F_IN_SYNC is unequal to the signal level on F_OUT
I think the FLT_CNT will stop increment after F_OUT = F_IN_SYNC and not reset to 0.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi, dw
Thank you for your reply.
If the FLT_CNT act as your think, the Filter can only work one time. I don't think it's reasonable.
Best Regards
Jamber
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi, dw
Thanks, I see the Bosch's usermanual, samely, there is no explicite description about the FLT_CNT's behavior after F_OUT output.
Best Regards
Jamber
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yes Jamber.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @Jamber
1) Does the FLT_CNT decremented?
-- No, I'm afraid not, unless a falling edge occurs.
2) If the cnt can't be reset, does it means the filter only can work one time?
-- For the FLT, it only can detect the rising edge but also the falling edge, it can reset the FLT_CNT when a low level reaches the filer parameters. In other words, it seems like an opposite mechanism versus detecting the rising edge.
BR,
Jeremy