Dec 11, 2022
07:23 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 11, 2022
07:23 PM
In the connection between TC377 and TLF35584, PORST and ROT are connected.
I would like to set the TLF35584 and TC377 to Standby mode, but I guess that the TC377 will reset before going to Standby because ROT goes from high to low when the TLF35584 transitions to Standby.
Therefore, I guess that TC377 will not transition to Standby mode.
Am my thought correct?
Any way to put both TC377 and TLF35584 into Standby mode?
Solved! Go to Solution.
1 Solution
Dec 12, 2022
03:15 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 12, 2022
03:15 AM
Hello,
When PMSWCR4.PORSTREQ = 0, SCR is not reset on warm PORST. You can refer to AP32465 for more details.
Thanks.
1 Reply
Dec 12, 2022
03:15 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 12, 2022
03:15 AM
Hello,
When PMSWCR4.PORSTREQ = 0, SCR is not reset on warm PORST. You can refer to AP32465 for more details.
Thanks.