Oct 21, 2022
01:46 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 21, 2022
01:46 AM
I am using TC337.
I set the PINA for wake-up trigger
.
When PINA reacts, what kind of process causes Wakeup?
What I want to know is whether the program restarts from the place before signal reception → Wakeup → Standby with PINA?
Also, is the CPU stopped during Standby?
I want to reset after wakeup. What kind of program should I do then?
3 Replies
Oct 21, 2022
05:42 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 21, 2022
05:42 AM
Hi,
Can you check the below thread?
Best Regards.
Oct 24, 2022
07:37 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 24, 2022
07:37 PM
I read the linked content but I don't understand how the wakeup works.
After the system goes into Standby, where in the code does the operation resume when PINA input is detected?
Oct 24, 2022
06:47 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 24, 2022
06:47 PM
Thanks.
I will refer to the content.