- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi.
I can not find how to handle unused pins in document.
Please tell me how do I handle unused GPIO and A/D pins?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello yamamoto. In general, I find this the easiest:
- Configure unused GPIO to input and activate internal pulldown
- Ground unused ADC
See "Recommendation for unused pins" in the TC399 PCB Design Guidelines application note AP32335, page 7:
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello yamamoto. In general, I find this the easiest:
- Configure unused GPIO to input and activate internal pulldown
- Ground unused ADC
See "Recommendation for unused pins" in the TC399 PCB Design Guidelines application note AP32335, page 7:
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi µC_Wrangler,
Thank you for your reply.
Unfortunately I can not access your link.
Could you confirm the link is available?
Best Regard.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
The link is updated with the MyICP link.
If you do not have access to the MyICP, You can refer to the link to get access.
Best Regards.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content