Announcements

Help us improve the Power & Sensing Selection Guide. Share feedback

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
Sakthivel
Level 3
Level 3
50 sign-ins 10 questions asked First like received

Hello there,

We planned to design a custom carrier board based on the Aurix family "SAK-TC397XX-256F300S BD" MCU, The board has 10 nodes of CAN interface, a 100-Mbit Ethernet PHY chip where RGMII goes from MCU to PHY chip, three I2C-based temperature sensors; UART for serial port; DAP connector for debugging and flashing the firmware, a few GPIOs for controlling the cooling FAN and the MCU will be powered by the "TLF35584QVVS1" PMIC.

We recently signed an NDA with Infineon to access restricted files. so please share. the required design files, hardware design guide, technical reference manual, PCB and Gerber files, and all the necessary documents related to the TC397XX MCU and TLF35584QVVS1 PMIC chips for designing a custom board.

Thanks,
Sakthivel

0 Likes
1 Solution
Nambi
Moderator
Moderator
Moderator
500 replies posted 50 likes received 5 likes given

Hi,

You can find the files in the link .

Please refer to the link to get access to the requested documentation.

Best Regards.

View solution in original post

0 Likes
1 Reply
Nambi
Moderator
Moderator
Moderator
500 replies posted 50 likes received 5 likes given

Hi,

You can find the files in the link .

Please refer to the link to get access to the requested documentation.

Best Regards.

0 Likes