Mar 22, 2022
09:23 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 22, 2022
09:23 AM
Hi,
We are using TC39B for our development. For our powertrain application, we would like to implement some functions on GTM MCS. One of the functions requires read out of adc conversion results. From the datasheet, I found out that it is possible with BRD instructions. But I could not find more informations
about how to get address of ADC channels that can be used in BRD instruction.
We are using following ADC channels.
AN8 - G1_CH0
AN16 - G2_CH0
AN24 - G3_CH0
Could you please share your suggestions what needs to be done here?
Thanks.
Regards,
Sep
We are using TC39B for our development. For our powertrain application, we would like to implement some functions on GTM MCS. One of the functions requires read out of adc conversion results. From the datasheet, I found out that it is possible with BRD instructions. But I could not find more informations
about how to get address of ADC channels that can be used in BRD instruction.
We are using following ADC channels.
AN8 - G1_CH0
AN16 - G2_CH0
AN24 - G3_CH0
Could you please share your suggestions what needs to be done here?
Thanks.
Regards,
Sep
1 Reply
Mar 27, 2022
10:38 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 27, 2022
10:38 PM
Hi,
1. You can refer to the below sections in "AURIXTC3XX_um_part2_v2.0.pdf"
i) 28.17.6 ADC Interface
ii) 28.17.6.1 Basic ADC Functions
2. You can refer to the below sections from the link "https://www.bosch-semiconductors.com/media/ip_modules/pdf_2/gtm/gtm-ip_specification_v3-1-5-1.pdf"
i) 15.6 ADC Interface
ii) 15.6.1 Basic ADC Functions
iii) 15.7.24 BRD Instruction
Best Regards.