使用GTM MCS多个通道ch 0,ch1,ch3,把三个通道代码拷贝到MCS RAM。
是不是把每个通道MCS_CH_PC寄存器写为自己代码的运行地址,然后再使能通道,每个通道就执行自己任务代码呢?
谢谢!!!
已解决! 转到解答。
Hi hoji,
MCS is a IP module from BOSCH which is not included in the basic training materials.
You can consult from FAE or disti for programming guide. Below is public for your reference.
https://www.bosch-semiconductors.com/events/gtm-techday-2017.html
https://www.bosch-semiconductors.com/media/events/techday_presentations/14_infineon.pdf
dw
Hi Hoji,
请问使用的是TC3还是TC2?May I ask which series you used? TC3XX or TC2XX?
There is a chinese video introduction about GTM MCS
https://videos.infineon-autoeco.com/pc/page/detail/87
dw
Dear DW:
Thank you!
I use TC3XX .
I have watched this video, but there are no explanation about this queston.
Hi hoji,
MCS is a IP module from BOSCH which is not included in the basic training materials.
You can consult from FAE or disti for programming guide. Below is public for your reference.
https://www.bosch-semiconductors.com/events/gtm-techday-2017.html
https://www.bosch-semiconductors.com/media/events/techday_presentations/14_infineon.pdf
dw