Announcements

Help us improve the Power & Sensing Selection Guide. Share feedback

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
cha1pi
Level 1
Level 1
5 replies posted 5 questions asked 10 sign-ins

While trying to flash my TC397 kit , I get this every time. Is there some setting I need to change

"::Loading HEX file ..........
:⚠️ The given program file is trying to write on reserved memory addresses, which will be skipped."

0 Likes
9 Replies
TBencher
Level 6
Level 6
25 solutions authored 25 likes received 5 questions asked

Hi,

if you did not actively try to put data on reserved memory areas, it seems you have the wrong project setup. Please start over again with a suitable setup.

 

Best regards,

TBencher

0 Likes
Di_W
Moderator
Moderator
Moderator
500 solutions authored 1000 replies posted 250 solutions authored

Hi cha1pi,

Have you tried to use UDE starter to load .elf? Have you used Memtool to load .hex?

dw

0 Likes
TBencher
Level 6
Level 6
25 solutions authored 25 likes received 5 questions asked

Hi dw,

I assume *.hex related to his post. I also assume ADS because this is always recommend if you start with the kits. 
But let's wait what he'll say 😉

Best regards,

TBencher

0 Likes
cha1pi
Level 1
Level 1
5 replies posted 5 questions asked 10 sign-ins

This is in the Aurix Development studio. even When I import projects from examples here : AURIX_code_examples/code_examples at master · Infineon/AURIX_code_examples · GitHub , I end up getting the same warning. The code still runs on my board

0 Likes
TBencher
Level 6
Level 6
25 solutions authored 25 likes received 5 questions asked

Hi,

you should setup a clean project for your board. Then try to compile. No warnings should appear. Don't use the example projects directly. Then, put the example code -just the code- in. Check for dependencies.  Afterwards try to compile again.  As a result, you should not have this warning anymore.

Best regards,

TBencher

0 Likes
TBencher
Level 6
Level 6
25 solutions authored 25 likes received 5 questions asked

Any news?

0 Likes
cha1pi
Level 1
Level 1
5 replies posted 5 questions asked 10 sign-ins

Hello,

So I cleaned and rebuild the project, I do get the same warning while flashing. "Don't use the example projects directly. Then, put the example code -just the code- in" . Do you mean to start a new project and then copy the code contents or the code file from the examples to my new project?

Dependencies seems to be fine

0 Likes
TBencher
Level 6
Level 6
25 solutions authored 25 likes received 5 questions asked

Hi,

just the content. But even without it, your project should be compilable without any warnings.

Best regards,

TBencher

0 Likes
TBencher
Level 6
Level 6
25 solutions authored 25 likes received 5 questions asked

Any news?

0 Likes