Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
Ashwini
Level 1
Level 1
10 questions asked 5 replies posted 10 sign-ins

Hello, I am studying clocking system chapter of AURIX_TC3xx  user manual in that below section 10.3 Clock Sources, I have came across  part 10.3.1.1 External Input Clock Mode  , in this section I am curious about how does this External Input clock mode works via EDSADC external modulator, Can any one show me light on how exactly EDSADC external modulator is working  as clock source?

0 Likes
1 Solution
TBencher
Level 6
Level 6
25 solutions authored 25 likes received 5 questions asked

Hi,

as far as I know if we regard to external clock source you need to provide at least an external crystal / ceramic resonator or an external stable clock source as mentioned in the documentation. EDSADC is an "Enhanced Delta Sigma ADC" which is actually not used for this purpose. Once you have your stable clock source -which you must have-, there is no need for getting any EDSADC channel involved.

Best regards,

TBencher

View solution in original post

4 Replies
TBencher
Level 6
Level 6
25 solutions authored 25 likes received 5 questions asked

Hi,

as far as I know if we regard to external clock source you need to provide at least an external crystal / ceramic resonator or an external stable clock source as mentioned in the documentation. EDSADC is an "Enhanced Delta Sigma ADC" which is actually not used for this purpose. Once you have your stable clock source -which you must have-, there is no need for getting any EDSADC channel involved.

Best regards,

TBencher

Thank you for clearing my doubt!!

 

0 Likes
LaneYE
Level 3
Level 3
25 sign-ins 10 replies posted 5 replies posted

Hello,Ashwini.

The DSADC module is for e-motor rotation decoding which integrate Delta/Sigma.It can product clock,but it's for modulator or demodulator shown in below figure.

LaneYE_0-1659106316511.png

The part 10.3.1.1 External Input Clock Mode that you mentioned is for CGU unit which generate bus clock, peripheral clock(fPER shown in up figure). In this mode, you just input external clock signal(eg:20MHz) to MCU.

Ashwini
Level 1
Level 1
10 questions asked 5 replies posted 10 sign-ins

Thank you for this explaination!!

0 Likes