- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I have a problem with offset compensation. I put offset compensation value, and then enable offset compensation value protect so the calibration algorithm does not overwrite it. But this is never applied on my measurements. I tried looking in drivers and there is nowhere to find where this offset is applied. I tried everything and offset just won't be applied. Can you please help me with this, I have no more ideas.
Thank you.
Best regards,
Hrvoje
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Please do not post queries on MC-ISAR products in the community as these are licensed products. You can contact your software provider for queries.
Thanks.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Please do not post queries on MC-ISAR products in the community as these are licensed products. You can contact your software provider for queries.
Thanks.