Aug 05, 2022
12:58 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 05, 2022
12:58 AM
Hi there,
Can HW parity check be used in master mode? From iLLD u can config a master ch to use parity check (<IfxQspi_SpiMaster_ChannelConfig>.parityCheck). But from manual the chapter ch20.8.3 'Parity' is under ch.20.8 'Slave Mode', implying it only work in slave mode.
So if I turn on parity check in master mode (<IfxQspi_SpiMaster_ChannelConfig>.parityCheck = TRUE), will it work?
I am working on TC234.
Thanks for reading, any reply is appreciated
Solved! Go to Solution.
1 Solution
Aug 06, 2022
05:43 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 06, 2022
05:43 AM
Hi User21797,
This bit is from register ECON, and it has meaning in Tx and Rx mode.
Please refer to attached table.
dw
1 Reply
Aug 06, 2022
05:43 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 06, 2022
05:43 AM
Hi User21797,
This bit is from register ECON, and it has meaning in Tx and Rx mode.
Please refer to attached table.
dw