- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
In THE AURIX Development Studio (ADS) project, I modified the LSL file, and loading failed: Flash programming failed appeared during debugging after compiling. But lauterbach can be successfully debugged. How to modify ADS configuration to complete debugging in ADS, thank you!
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dear User,
For Lauterbach, it may use DAP/JTAG interface. Generally, Infineon Triboard has on-board miniwiggler which uses USB-UART bridge to ASC0 interface for debugging.
When you use Triboard and ADS(Aurix Development Studio), the default setttings are using DAS driver for USB-UART bridge, and communicate with on-board miniwiggler.
Otherwise, the startup hardware setting also make sense. When you use Triboard, should take care of 4-pin Dip switch for HWCFG settings.
Details please refer to Chapter 3.17 Debug System in TriboardManual-TC3xx.pdf .
dw
dw
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dear User,
For Lauterbach, it may use DAP/JTAG interface. Generally, Infineon Triboard has on-board miniwiggler which uses USB-UART bridge to ASC0 interface for debugging.
When you use Triboard and ADS(Aurix Development Studio), the default setttings are using DAS driver for USB-UART bridge, and communicate with on-board miniwiggler.
Otherwise, the startup hardware setting also make sense. When you use Triboard, should take care of 4-pin Dip switch for HWCFG settings.
Details please refer to Chapter 3.17 Debug System in TriboardManual-TC3xx.pdf .
dw
dw