- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I'm trying to run the sample "ble_wifi_onbording" that comes with "STM32 Connectivity Expansion Pack 1.1.0", but I get the following error.
***************************
Wi-Fi Onboarding Using BLE
***************************
Timeout while waiting for high throughput clock
SDIO firmware download error, whd_bus_sdio_init failed at 454
Failed to [1667] handle_hci_rx_data_ready(): unknown type (0x00)
I get the same error with the other sample "wifi_scan".
******************* WiFi-Scan app *******************
Push blue button or send any symbol via serial terminal to continue...
CYW43xxx detected
Timeout while waiting for high throughput clock
SDIO firmware download error, whd_bus_sdio_init failed at 454
Failed to initialize Wi-Fi
What are the possible causes?
<Device used>
・STM32H747I-DISCO
STM32H747I-DISCO STMicroelectronics | Mouser
・LBEE0ZZ1WE-TEMP
LBEE0ZZ1WE-TEMP Murata Electronics | Mouser
・Wi-Fi/BT module: 1DX M.2 Module
1LV M.2 Module - Embedded Artists
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The target module setting was different
・OK: 1DX M.2 (CYW4343W)
・NG: 1LV M.2 (CYW43012)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @hi118 ,
Can you please verify again whether the steps given in the document is followed properly.
I have attached the user guide again for your reference .
Thanks,
Rakesh B G
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @Rakesh_BG
Thank you for your reply.
I have checked the user guide, what do you think is the setting or procedural mistake that causes this error?
It would be helpful if you could lend me your wisdom.
Regards,
hi118
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The target module setting was different
・OK: 1DX M.2 (CYW4343W)
・NG: 1LV M.2 (CYW43012)