- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I'm attempting to program a CYW43907 on a custom PCB. The JTAG pins are exposed and I have the chip in boot mode. According to this it should be possible to use the MiniProg4 to program via JTAG:
https://community.cypress.com/t5/PSoC-5-3-1-MCU/Miniprog-4-JTAG/m-p/265859
According to this MiniProg4 supports the CYW43907:
https://www.cypress.com/products/psoc-programming-solutions
Yes I cannot connect. See attached screenshot.
How can I program?
(I also have a MiniProg3 which can detect the chip via a JTAG scan, however it doesn't seem to have support for a CYW43907)
Solved! Go to Solution.
- Labels:
-
PSoC 4 MCU
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
As per the first link, MiniProg4 doesn't support program/debug via JTAG. CYW43907 supports JTAG. MiniProg4 supports SWD.
Thanks
Aditi
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @leaf we are checking if it is feasible to program the 43907 with the miniprog4 out of the box or if some changes are necessary.
Regards, Vivek
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
As per the first link, MiniProg4 doesn't support program/debug via JTAG. CYW43907 supports JTAG. MiniProg4 supports SWD.
Thanks
Aditi