- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I use "fqacurcy" command to set CYW4354 to transmit CW(continuous wave, non-modulated) signal, it works, but the CW signals are transmitted thru both Core0/Core1.
I tried to add "txchain" command to control it, but the CW signals are still transmitted thru both Cores.
How can I set it to transmit CW signal thru specified path?
Thanks for your help.
Frankie
Solved! Go to Solution.
- Tags:
- cyw4354
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @FrYa_4831451 ,
When using the CW mode testing the power is always maximum and cannot be change, the maximum power is set by the CLM.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @FrYa_4831451 , Could you please share us the full command list used to set continuous wave?
From the wl document link -> https://community.cypress.com/t5/Public-Archive/WL-Tool-for-Embedded-802-11-Systems-CYW43xx-Technica... the command "txchain" take the values 1 - Chain 0 only
2 -Chain 1 only
3 -Chains 0 and 1
Could you please conform if you tried setting txchain to 1 or 2?
Regard, Vivek.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Vivek,
The commands I used are as below:
wl down
wl mpc 0
wl txchain 1
wl up
wl band b
wl out
wl fqacurcy 1
Regards.
Frankie
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Frankie,
-> Could you please add " txchain=1" in the NVRAM file and check if the issue still persist?
-> Does the core 0 and 1 both transmit with txchain 2 or 3?
Regards Vivek.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Vivek,
I add the following command in NVRAM, and it can transmit the single by main path only, and I will try to modify it from "1" to "2", and check the signal can be transmitted by aux path or not.
rxchain=1
txchain=1
aa2g=1
aa5g=1
One more question, can I adjust the TX power level for this CW test by wl command?
Thanks.
Frankie
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Any update for TX CW power level adjusting by wl command? or it can't be supported?
Thanks.
Frankie
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @FrYa_4831451 ,
When using the CW mode testing the power is always maximum and cannot be change, the maximum power is set by the CLM.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Vivek,
Got it and thanks for your help.
Regardds.
Frankie