- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Guys,
I will be working on the Laird Sterling LWB5+ module which is based on CYW4373 chip
I want to configure to create an access point so I can connect to using my smartphone
I want to know if this module supports creating WI-FI access points, also please provide me with corresponding documents / datasheets /user manual that can help me
Big thanks
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @Yahya_Yozo ,
The direct example code for access point is not available but it is achievable using the API's available. Basically refer that document and setup things for wifi scan and then you can go for access point implementation.
Thanks,
Rakesh B G
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @Yahya_Yozo, To help me understand your setup could you please let us know the following
-> Could you please let us know if you are using a Microcontroller or a Linux microprocessor to communicate with the CYW4373?
Regards
Vivek
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I'll be using an STM32 MCU to communicate with CYW4373
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @Yahya_Yozo ,
You can use stm32 connectivity expansion pack to achieve the requirement.
The link for user guide is attached.
Thanks,
Rakesh B G
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This guide shows an example of a Wi-Fi scan for the available access point , I want the opposite, I want the module to create an access point ?
Is this doable ?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Please provide me with the documents / datasheets /user manuals that can help me, thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @Yahya_Yozo ,
The direct example code for access point is not available but it is achievable using the API's available. Basically refer that document and setup things for wifi scan and then you can go for access point implementation.
Thanks,
Rakesh B G