- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Sir,
We use CYW43438 as softAP with dhd driver, and use smart phone as client, and their distance around 5m.
Firmware version: bcm43438-7.46.58.11
While doing ipef throughput test, throughput will keep 1x Mbps around several seconds in channel 1 or 11, then down to 0 Mbps.
We have to disconnect and re-connect for recovery.
For same test in channel 6, it seems testing good, but only keep normal around several minutes.
What could we do to keep throughput test stability in AP mode?
Solved! Go to Solution.
- Tags:
- softAP CYW43438
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @LeonH ,
This request cannot be supported on the Community and request you to raise a support ticket, For more details on this please contact the Infineon sales team.
Regards
Vivek
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @LeonH ,
This request cannot be supported on the Community and request you to raise a support ticket, For more details on this please contact the Infineon sales team.
Regards
Vivek
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @LeonH, we see that you have raised a support ticket. Could you please let us know if we could close the community post?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Vivek,
Yes, thank you.