- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Use CYW920719B2Q40EVB-01 EVALUATION KIT by Modustoolbox,Application:HAL-PUART,cannot realize the result of this program.
Hardware connection are as follow:
Logic Analyzer CH0--J10 TX
CH1--J10 RX
CH2--D1
Software operation situation:
Send character 4 to the SoC three times,but no response.
Did I do something wrong?
Solved! Go to Solution.
- Labels:
-
AIROC™Bluetooth
-
ispn:38626:1:0
-
l1:314:1:0
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Nichol,
The application code sent out some text on reset. It is also not received on your COM program. I doubt you made any changes to device configuration. Anyway, I have attached the screenshot of mine for your reference.
Regards,
Pong
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Nichol,
It is not clear on your photo, is there a jumper between J10(5-6)(TX) and J10(7-8)(RX)?
Regards,
Pong
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,Pong,
the jumper both have been taken off.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This pin now connected. The same result.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Pong,
The Hardware and software config are as follows,should I set the Bluetooth address first?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Nichol,
HAL_PUART does not involve Bluetooth, no need to set Bluetooth address. Your settings are similar to mine.
Did you program the board?
Regards,
Pong
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Pong,
The programming screenshot is as follows,thanks.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Nichol,
The application code sent out some text on reset. It is also not received on your COM program. I doubt you made any changes to device configuration. Anyway, I have attached the screenshot of mine for your reference.
Regards,
Pong