Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

AIROC™ Bluetooth Forum Discussions

shlim
Level 4
Level 4
50 replies posted 50 questions asked 100 sign-ins

Hi~

When I tried to debug  sample application(BLE_Eddystone), I found an error below.

------------------------------------

Debugger exited unexpectedly during run. Encountered error (Target disconnected See output window for more information.)

I want to debug this devcie without error

 

BRs

 

 

Daniel Lim
0 Likes
1 Solution
Yugandhar
Moderator
Moderator
Moderator
1000 replies posted 5 likes given First comment on blog

Hello,

In Design Wide Resources ->System, please select the Debug Select to SWD as shown in attached image. 

Thanks,

P Yugandhar.

View solution in original post

6 Replies
shlim
Level 4
Level 4
50 replies posted 50 questions asked 100 sign-ins
 
Daniel Lim
0 Likes
Yugandhar
Moderator
Moderator
Moderator
1000 replies posted 5 likes given First comment on blog

Hello,

Please refer to the attached project.  Please let me know if this helps.

Thanks, 

P Yugandhar.

Thank you for  your prompt reply

But unfortunately I didn't solve the problem

I compared the source first and merged some differences. But debugging failed.

So, I used full integration by importing attached source file. But still failed.

I attached eddystone source file only.

please check it again

BRs

Daniel Lim
0 Likes
shlim
Level 4
Level 4
50 replies posted 50 questions asked 100 sign-ins

Any progress ?

Daniel Lim
0 Likes
Yugandhar
Moderator
Moderator
Moderator
1000 replies posted 5 likes given First comment on blog

Hello,

In Design Wide Resources ->System, please select the Debug Select to SWD as shown in attached image. 

Thanks,

P Yugandhar.

shlim
Level 4
Level 4
50 replies posted 50 questions asked 100 sign-ins

It works very well

Thank you for your support

Daniel Lim
0 Likes