- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
I am looking for a sensor that can measure the position of a flywheel of an engine.
Usually this is done with inductive sensors or hal sensors however my engine has 4 magnets on the flywheel so I think those would interfere with the signal I need.
The sensor would need to take over the ignition timing for my engine so I need one that is precise enough to do that..
I was thinking optical to measure teeth on the flywheel with one teeth grind out so it knows where the rotation starts/ends. Would this work for something like this? Rpm range would be up to 8000rpm and should work from standstill if possible for hand starting. Any help is echatrandom appreciated.
- Labels:
-
3D Hall Sensors
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @VictorJohnsonan ,
We provide solutions for different applications using Magnetic sensors, and would like to help you build your application.
If you could provide a general design of the system. Like, how the magnets will be placed on the flywheel, type and design of magnets and also the design of flywheel.
Thanks and regards,
Yashraj
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @VictorJohnsonan ,
Closing this thread due to inactivity. If you need further support, please create a new thread.
Thanks and regards,
Yashraj